Exit Mould Remover Cleaning Spray 500mL
Exit Mould attacks moulds at the source and the special detergent additive helps leave the surface sparkling clean.
This mould remover cleaning spray can be used indoors and outdoors:
- Bathroom and laundry.
- Tiles, grout and walls.
- Rubber bath mats.
- Fridge door seals.
- Boats.
- Under eaves.
- Concrete patios.
- Most mouldy areas.
Keep out of reach of children. Not to be taken. Corrosive. Strongly alkaline. May produce severe burns. Attacks skin and eyes. Warning - Vapour may be harmful. Ensure adequate ventilation when using. May give off dangerous gas if mixed with other products. Wear protective gloves when using. Wear either old clothes, or a protective covering as product can cause discolouration of clothing and textiles. Wash hands after use. Precautions - Turn nozzle to off position after use. Do not squeeze trigger in off position as this may cause product to spit when turned on. CautionKeep out of reach of children Read safety directions before using PrecautionsTurn nozzle to off position after use. Do not squeeze trigger in off position as this may cause product to spit when turned on. Safety DirectionsKeep out of reach of children. Not to be taken. Corrosive. Strongly alkaline. May produce severe burns. Attacks skin and eyes. Warning - Vapour may be harmful. Ensure adequate ventilation when using. May give off dangerous gas if mixed with other products. Wear protective gloves when using. Wear either old clothes, or a protective covering as product can cause discolouration of clothing and textiles. Wash hands after use.
Store in a cool place out of direct sunlight. Do not place container on surfaces likely to suffer discolouration from spills. Avoid Contact With:Textiles, unpainted metals, damaged paint surfaces or older enamel. Spot test on all surfaces before use in an inconspicuous area, particularly baths, basins, tiles, coloured grout and painted surfaces to ensure no discolouration occurs. Directions for Use: do not swallow1 Point trigger away from face. Hold down safety tab on top of nozzle. 2 Turn nozzle to "on" position. Do not squeeze the trigger when it is in "off" position as this may cause it to spit when turned on. 3 Spray from 20-30cm away from targeted area. Leave for 30s for light stains and 10min for tough stains. 4 Rinse with water and then wipe off. Repeat steps 2 to 4 if required. 5 When finished, turn nozzle to "off" position, until safety tab locks in position.